Dock for VoCore v0.5

VoCore v0.3 is not that easy to test, so I make a dock for v0.5.
Its size is 2.5×2.5×1.6. Once connect it to VoCore v0.5, the total size of the two will be 2.5×2.5×2.0.

67B7138F-94C0-453E-87A7-A1136FFB0FF2

 

This dock contains three parts.

A: USB1(left bottom) is used for power +5.0V, it should be connected to USB power.
B: USB2(top right) is a full function USB.
C: RJ45(right bottom) is for WLAN/LAN connection, connected to EPHY_P0.

It is not the final version of the dock.

From Apr.23, I kept one of my board running. 🙂
0E34CAA4-EA6E-4422-9D37-B3F3491F5989

3 thoughts on “Dock for VoCore v0.5

  1. joyhope

    It seems easy to use.

    Is it possible to provide the TTL interface for RS232? I think simple pin is enough. It will helpful for debug.

    It is good that motherboard gave stamp interface while dock provide the pin interface.

    1. vonger Post author

      New version is not half-hole board, so it should be easy for test/connect.

  2. god

    Is it only wire routing or there’s some resistor/capacitor/other components in addition to actual interface connectors?

Comments are closed.